ProRep Neodymium SpotLamp 40w ES Screw

Simulates daylight to show the animal's natural colours
Creates a local hot spot for basking species
Provides light and heat and increases ambient air temperature
Encourages natural thermo-regulatory behaviour

Directions:
Select an appropriate colour lamp to emphasise the features of your set-up and to simulate your animal's natural environment. Make sure that the wattage is appropriate for the animal and enclosure size and construction.

Use in an approved fitting of the correct type. Mount the light directly above the basking site approximately 1/3 from one end of the tank to create a temperature gradient allowing natural thermo-regulatory behaviour.

The use of a dimming thermostat is highly recommended to prevent overheating. The use of a guard is essential to ensure that your animal cannot get burnt.

SAFETY INSTRUCTIONS FOR FITTING, REPLACEMENT AND DISPOSAL
·         Ensure that the electricity supply is switched off
·         Check that the bulb type and wattage is compatible with the fitting
·         Allow the bulb to cool down before handling
·         If in any doubt, consult a qualified electrician
·         Please dispose of lamps and packaging in a responsible manner

Available in the following sizes (BC Bayonet B22)

LMS260 Neodymium SpotLamp 40w
LMS265 Neodymium SpotLamp 60w
LMS270 Neodymium SpotLamp 100w

Available in the following sizes (ES Screw E27)

LMS360 Neodymium SpotLamp 40w
LMS365 Neodymium SpotLamp 60w
LMS370 Neodymium SpotLamp 100w